当前位置：中博教育 > ACCA > 学习指导 > ACCA AA工资制度五个阶段的审计

ACCA AA工资制度五个阶段的审计

文章来源：ACCA全球官网

发布时间：2021-09-29 13:40

阅读：966次

Stages in a wages system

Five stages are shown below and typical controls identified are linked to relevant control objectives.

(i)Setting up master file data

Robust recruitment procedures are required before new employees are entered on the wages master file.Interviews should be undertaken involving senior staff to ensure the new employee has the required skills.New starters’forms should be completed in the human resources(HR)department and copies retained along with contracts of employment.Changes to standing data on the master file should be performed by staff who are independent of processing payroll.The wages master file contains all the standing data about employees,such as name,address,date of birth,date of starting employment,employee number,rate of pay and tax code.

Relevant controls

Changes to master file data such as rates of pay and new starters/leavers should be supported by forms approved by a senior responsible official.(Control objectives 2 and 4)

Access to the master file should require a responsible official’s password and a log of standing data amendments should be produced and reviewed.(Control objectives 2,3 and 4)

An independent check should be performed of standing data amendments log to supporting documentation.(Control objectives 2,3 and 4)

(ii)Recording wages due

Clock cards are often used to record the hours that employees enter and leave the premises.Modern equivalents would include employee ID cards which are swiped by an electronic card reader.In this scenario employees are paid based on hours worked.If employees are paid in accordance with work completed job cards may take the place of clock cards.

Relevant controls

Supervision of clocking on points and control over blank clock cards(or employee ID cards)are essential.(Control objective 1)

Clock cards should be authorised by a responsible official before they are sent to the payroll departments.(Control objectives 1 and 3)

HR department should keep blank clock cards or ID cards,which are only issued for new employees with contracts of employment.(Control objective 2)

(iii)Calculation of wages

Hours worked should be converted to a gross wage by reference to the employee’s hourly rate of pay and deductions such as payroll taxes are made to calculate net pay.Software is normally used to produce the weekly payroll and calculation errors are less likely than with manual systems.Gross wages should be based on a standard working week(for example,40 hours)and if overtime has been worked this should be picked up from the clock card.However,in some systems,authorised lists of overtime worked during the week are entered so that the revised gross wage can be calculated.

Relevant controls

Overtime forms/listings should be reviewed and authorised by responsible managers before input to the system.(Control objectives 1 and 3)【点击免费下载>>>更多ACCA学习相关资料】

Software controls should include data validation(edit)checks on the data fields included on transactions,and include reasonableness,existence,range and character checks.Error reports should be produced which list rejected items–for example,employee numbers entered that do not exist.Also exception reports should list transactions that have been processed but which exceed certain pre-determined limits–for example,employees earning more than$2,000 per week or those who worked more than 30 hours of overtime.It is very important that both reports are investigated closely and if necessary data corrected and re-input.(Control objectives 2 and 4).

A sample of payroll calculations should be checked by senior responsible official and the payroll initialled.(Control objective 5)

(iv)Payment of wages

As indicated earlier employees should either be paid in cash or by bank transfer.In the case of cash a cheque should be signed,preferably by two senior responsible officials(normally directors in small companies).Once collected from the bank the cash should be included in pay packets with payroll slips for subsequent distribution to employees.

Relevant controls

The payroll should be reviewed by a senior responsible official before the payroll cheque is signed.If employees are paid by bank transfer,the list should be authorised before being sent to the bank.(Control objectives 2 and 3)

Two individuals independent of the processing of wages should be involved in the make up of pay packets and during the wages pay-out.(Control objective 2)

Employees’signatures should be required when wages are collected,as evidence of receipt.If employees are absent their wage packets should be entered in an uncollected wages book and returned to a safe under the control of an independent responsible official(eg the cashier).There should be a requirement for formal identification procedures to be carried out on the subsequent collection of wage packets.(Control objective 2)

(v)Accounting for wage costs and deductions

Payroll software should automatically transfer total wage costs and deductions such as tax and pension contributions to the appropriate accounts in the general(nominal)ledger.Outstanding wages owed to employees or deductions not yet paid over to the relevant third parties should be accrued and disclosed as‘other payables’.

Relevant controls

Monthly comparison of actual and budgeted payroll costs and investigation of significant variances.(Control objective 6)

Independent reconciliation of total pay and deductions between one payroll and the next.(Control objective 6)

Annual completion of tax returns and reconciliation to total tax deducted.(Control objective 7)

The above comparisons and reconciliations should be performed by senior responsible officials who are independent of the payroll department–for example,management or financial accounting staff.

相关阅读：【ACCA AA工资审计内部控制】

2022年ACCA最新学习资料包

请大家认真填写以下信息，获取2025年ACCA学习资料包，会以网盘链接的形式给到大家，点击免费领取后请尽快保存。